HD2304.0K Manometer-Thermometer, input for SICRAM module PP471 to connect probes TP704 and TP705 series. Temperature measurement with Pt100 probe complete with SICRAM module, measuring range -200°C +650°C. Storage of maximum, minimum, average value.
Functions: REL, HOLD and auto power off which can be disabled, IP 67 protection degree.

The HD2304.0 is a portable instrument with a large
LCD display. It performs measurements of absolute,
relative and differential pressure, and temperature.
The PP471 electronic module is used to measure the pressure. The PP471 electronic module works as an interface between the instrument and the TP704 and
TP705 series Delta Ohm probes. The temperature is detected with immersion, penetration, contact or air
Pt100 probes with SICRAM module or 4 wire direct
Pt100 probes.
The temperature probes are fitted with SICRAM
module and the factory calibration settings are
already memorized inside.
Upon turning on the instrument automatically
detects them.

The Max, Min and Avg function calculate the maximum, minimum or average values.
Other functions include: the relative measurement REL, the HOLD function, and the automatic
turning off that can also be disabled.

INSTRUMENT TECHNICAL CHARACTERISTICS
Instrument
Dimensions (Length x Width x Height) 140x88x38mm
Weight 160g (complete with batteries)
Materials ABS
Display 2x41⁄2 characters plus symbols
Visible area: 52x42mm
Operating conditions
Operating temperature -5…50°C
Stocking temperature -25…65°C
Working relative humidity 0…90%RH without condensation
Protection degree IP67
Power
Batteries 3 1.5V type AA batteries
Autonomy 200 hours with 1800mAh alkaline batteries
Power absorbed with instrument off 20μA
Measuring unit °C - °F - Pa - hPa - mbar - bar - atm - mmHg - mmH2O - kgf/cm2 - PSI - inchHg
Connections
Input module for the probes 8-pole male DIN45326 connector
Measurement of temperature by Instrument
Pt100 measurement range -200…+650°C
Resolution 0.1°C
Instrument accuracy ±0.1°C
Drift after 1 year 0.1°C/year
Common characteristics
Resolution 0.1°C
Temperature drift @ 20°C 0.003%/°C

ORDER CODES

HD2304.0K: The kit is composed of the instrument HD2304.0, SICRAM interface
module PP471, 3 1.5V alkaline batteries, operating manual, case.
The probes must be ordered separately.

Probes complete with SICRAM module

PRESSURE MEASUREMENT PROBES
PP471: SICRAM interface module between instrument and TP704 and TP705
series Delta Ohm probes. Cable length 2 metres. The list of pressure
probes is outlined in the technical data table.

TEMPERATURE MEASUREMENT PROBES
TP472I: Immersion probe, sensor Pt100. Stem Ø 3 mm, length 300 mm.
Cable length 2 metres.
TP472I.0: Immersion probe, sensor Pt100. Stem Ø 3 mm, length 230 mm.
Cable length 2 metres.
TP473P.0: Penetration probe, sensor Pt100. Stem Ø 4mm, length 150 mm.
Cable length 2 metres.
TP474C.0: Contact probe, sensor Pt100. Stem Ø 4mm, length 230mm, contact
surface Ø 5mm. Cable length 2 metres.
TP475A.0: Air probe, sensor Pt100. Stem Ø 4mm, length 230mm.
Cable length 2 metres.
TP472I.5: Immersion probe, sensor Pt100. Stem Ø 6mm, length 500 mm.
Cable length 2 metres.
TP472I.10: Immersion probe, sensor Pt100. Stem Ø 6mm, length 1000mm.
Cable length 2 metres.