KINAX POSITION TRANSDUCERS

KINAX 2W2 Programmable Angular Position Transmitter

KINAX 2W2 Programmable Angular Position Transmitter

The KINAX 2W2 Angular Position Transmitter converts the angular position of a shaft into a load independent direct current signal, proportional to the angular position. 
The unit is contact free and has minimal mechanical abrasion on the input shaft. 
It technically extends the delivery program of angular transmitters with a programmable version and thus creates a number of new technical application possibilities.

Angular Position Transmitter

• Program any angle measurement from 0...5º to 360º
• Digital output via RS-232 (Software supplied with each
  device)
• 4...20mA Analog output for direct display
• Compact rugged non-contact design virtually eliminates
  wear
• Exact size replacement for KINAX 3W2 Analog device for easy upgrades
• Replaces potentiometer feedback system with a single component
• 48mm Diameter, < 30mm mounting depth for low profile installations

• Type of protection "Intrinsic safety" EEx ia IIC T6 / Can be mounted within the hazardous area 
  ( Data on explosion protection")

• Simulation of measured values / The testing of the subsequent device chain is already possible
  during the installation phase

• Measured value acquisition / Display of the instantaneous value and a trend graph of the measured
  value on the screen

• Adjustment / Independent fine adjustment of the analog output, zero position and measuring range

• Characteristic of the output value / Programmable as a linear, V-characteristic, or any characteristic curve

• The shaft can be turned through a full 360°

• Patented measuring method

The KINAX 3W2 Angular Position Transmitter converts the angular position of a shaft into a load independent direct current signal, proportional to the angular position.
The unit is contact free and has minimal mechanical abrasion on the input shaft.
It is a technically purposeful complement to the angle transmitter program.
This compacter version is made possible by incorporating newly developed, highly integrated CMOS circuitry.

• Non-Contact, Vibration Resistant Technology
  Outlasts Potentiometers
• Any Angle, 10º-270º with up to 60% Adjustability
• Output Signals from 0...1mA to 0/4...20mA
• Shaft Diameter: 2mm, 6mm, ¼"
• Intrinsically Safe Versions Available
• Typical Applications: Valve Position, Cutting Blade
  Angle, Water Cannon Position

• Measuring input: Angular position  range limits Angular position 0…5° to 0…270°

• Capacitive scanning system / Non mechanical abrasion, low annual maintenance

• Low influence from bearing play, < 0.1%

• Accuracy < 0.5% for ranges < 150°

• Torque < 0.001 Ncm

• Drive shaft fully rotatable without stops

• For building into other equipment and as an OEM product / Very compact made
  only 48 mm in diameter

• Marine version also available as per Lloyd’s Register of Shipping

• Available in type of protection "Intrinsic safety" EEx ia IIC T6 / Can be mounted within the hazardous area  ( Data on explosion protection")