ITU-100 VOLTAGE TRANSMITTER

ITU-100 Voltage transmitter computes RMS current and converts the RMS value to a proportional 0-20mA output current. The wide frequency range, DC to 10kHz (Option 1: DC-100kHz) yields excellent accuracy for sinusoidal as well as nonsinusoidal signals (pulsed systems) and signals containing DC components. The 0-20mA output current is galvanically isolated from input and electronics supply. Three transmitters can be hooked-up in a 3-phase system to monitor total voltage, or average voltage by simply adding the transmitter output currents in a ammeter or a common scaling resistor. The transmitter is well suited to monitor electrical equipment. The 0-20mA signal can be transmitted over long distances (100m - 500m) without loss of accuracy. Galvanic input/output isolation yields maximum operator safety and eliminates ground loop problems.

• Measures RMS Voltage

• Suitable for 1- and 3-phase system

• Suitable for pulsed systems

• Output isolated from input

• DC-10kHz (100kHz)

• 0.2% accuracy

ITU-100 Voltage Transmitters Product Description ITU-100 120V, 250V and 400V

Options Option Description 01 Frequency range DC-100kHz 02 Nonstandard current ranges

 
ITU-100 Specification (20°)

ITU-100 Voltage Transmitter	Ranges	120V, 250V and 400V available
	Accuracy	50-60Hz, ±0.2% of output ±0.2% of range DC-1kHz, ±0.3% of output ±0.3% of range 1-10kHz, ±1.5% of output ±0.5% of range
	Output	0-20mA for nominal range max. linear output 0-30mA.
	Maximum Input	180V, 375V and 600V resp.
	Temp. coefficient	0.02% of full scale (20mA)
	Response time	0.5 sec. for 0-90% of final value
	Crest factor	Peaks 5 times selected range will not degrade accuracy
	Input/Output isolation	2kV, 50Hz, 1 minute input/output capacitance = 20pF
	Output load	0-300Ω max. at 30mA, output current change = -5uA/100Ω
	Current summation	The 0-20mA output current of several transmitters may be summed in a common resistor. The total voltage across the resistor should always be less than 9V (internal limitation)
	Supply	230V (+20%/-10%) / 20mA (110V on request)
	Case	Rigid plastic case for wall mounting, or DIN46277 support rail mounting
	Size	H x W x D, 70 x 100 x 147mm 70 x 100 x 161 for 50A transmitter
	Weight	450gr.