MECP100 PNEUMATIC HAND PUMP

MECP100 Pneumatic Pressure Pump. Pneumatic Hand Pump for Calibration Vacuum to 100 PSI.
The Pneumatic Hand Pump is designed to be a simple to use pressure and vacuum source for calibrating process control instrumentation.
Combined with one of our pressure calibrators, the pump makes a complete Pneumatic and Vacuum Calibration System for low pressure applications. This vacuum pump provides a source of air pressure,
0-100 psi, or vacuum, 0-28" Hg.

• Ease of use

• Fine adjust vernier

• Fine release bleed valve

• Vacuum to 100 psi

• Kits available

• Field Serviceable Valves

The rugged and reliable design of these hand pumps and the fine adjustment controls added to their design provides a low cost way to verify the performance of pressure instrumentation.

MECO100 Hand Pumps can be purchased independently, or in a kit including carrying case, NPT adapters, seals, and hoses.
Pressure Calibrators and Pressure Gauges are also available. Please check Table above.

The Pneumatic Pressure Pump Kit includes:

MECP100 Pneumatic Pressure Pump
Hard Sided Carrying Case
(2) Quick Disconnect Fittings
User Manual and Teflon Tape
Calibration Hose

Pump Specification:

Hand Pump Max. Rated Pressure: 100PSI (7 BAR) Max.
Rated Vacuum: –12.00PSI (–.85 BAR) Max.
Leak Rate1: £0.12PSI/minute after a 1 minute stabilization period
Wetted Materials: Aluminum, Silicon, Neoprene, Stainless Steel, Buna-N
Note 1: Does not include temperature effects
In-line Filter
Inlet fitting: 1/8" brass female NPT
Outlet fitting: 1/8" brass male NPT Length: 2.125 in.
Flange diameter: 1.875 in.
Housing diameter: 1.560 in.
Max. pressure: 100 psi Max. temperature: 200°F
Max. flow: 10 SCFM
Burst pressure: 375 psi
Filtration: 1 micron