METRISO 1000A Insulation Resistance Tester cost effective, analog insulation tester for electrical systems.
Up to 1000 V per EN 61 557 parts 1, 2 and 4 (VDE 0413 parts 1 and 4).
Test voltages: 50 V, 100 V, 250 V, 500 V, 1000 V. Measuring ranges to 400M Ohm.
Low-value resistance measurements to 4 Ohm. Complete with carrying bag.
|METRISO 1000A||1000 Volt Insulation Resistance Tester|
Nominal voltages 50 V, 100 V, 250 V, 500 V and 1000 V.
This instrument is suited for measurement of insulation resistance at voltage-free devices and systems
with nominal voltages of up to 1000 V, and for the insulation testing of earth conductors,
protective conductors and bonding conductors, including junctions and connections.
Quick testing with signal lamp.
The signal lamp in the test prod serves to illuminate the work area, and also indicates an evaluation of
the insulation resistance as OK or Failure.
As long as this lamp is lit, the minimum values for insulation resistance per DIN VDE 0100 have been met.
Low impedance measurement 0 ... 4 Ohm.
Low impedance measurement in accordance with DIN VDE 0413, Part 4 is also possible.
Voltage measurement to 1000 V.
The instrument is also equipped with a 1000 V measuring range for direct and alternating current.
This is especially advantageous for the testing of devices for the absence of voltage, and the discharge
of capacitive devices under test.
Minimal use of batteries.
Measurement only occurs when the ON/OFF button is depressed.
This provides for long service life of the batteries.
Dial gauge with signal lamp.
The condition of the batteries is indicated by the color of the signal lamp at the left side of the dial
gauge. This lamp also serves to indicate that the instrument is switched on.